How to make oral steroid oils

POST BY RAWSGEAR MANUFACTURER

For each hormone I listed ingredients needed

Anadrol
Highest concentration made – 50mg/ml
Per 1 gram of Oxymetholone you will need:
8.4 ml’s of PEG 300
10.5 ml’s 190 Proof Grain Alcohol

Anavar
Highest concentration made – 20mg/ml
Per 1 gram of Oxandrolone powder you will need:
9.8 ml’s of PEG 300
39.2 ml’s of 190 Proof Grain Alcohol

Armidex
Highest concentration made – 5mg/ml
Per 1 gram of Anastrozole powder you will need:
19.9 ml’s PEG 300
179.1 ml’s of 190 Proof Grain Alcohol

Clomid
Highest concentration made – 50mg/ml
Per 1 gram of Clomiphene Citrate you will need:
11.3 ml’s of 190 Proof Alcohol
7.6 ml’s of Glycerol

Dianabol
Highest concentration made – 50mg/ml
Per 1 gram of Methandrostenolone powder you will need:
19 ml’s of 190 Proof Grain Alcohol
No PEG needed. Follow the no PEG recipe.

Femara
Highest concentration made – 5mg/ml
Per 1 gram of Letrozole powder you will need:
19.9 ml’s PEG 300
179.1 ml’s of 190 Proof Grain Alcohol

Nolvadex
Highest concentration made – 20mg/ml
Per 1 gram of Tamoxifen Citrate you will need:
29.4 ml’s of 190 Proof Alcohol
19.6 ml’s of Glycerol

Proviron
Highest concentration made – 50mg/ml
Per 1 gram of Mesterolone you will need:
8.4 ml’s of PEG 300
10.5 ml’s 190 Proof Grain Alcohol

Winstrol
Highest concentration made – 25 mg/ml
Per 1 gram of Stanzolol you will need:
7.8 ml’s of PEG 300
31.2 ml’s of 190 Proof Grain Alcohol

Solutions requiring PEG and 190 Proof Alcohol

Step 1. Prepare a hot water bath. Boil water in microwave or on a pot. Once boiling starts remove from heat.
Step 2. Place PEG and powder in beaker.
Step 3. Place the beaker deep enough in to the water so that the hot water is level with the PEG and powder. Gently swirl or stir with a stir rod until solution is clear. Reheat water as needed.
Step 4. Allow PEG to cool some. Then add in your 190 proof alcohol. You don’t have to do this drop by drop but don’t just dump it in. Pour it in slowly.
Step 5. Stir or gently shake until mixed.

For recipes that do not require PEG.

1. Mix powder and 190 proof alcohol.
2. Stir with stir rod or shake. Most powders that do not require PEG will disolve no problem. If heat is needed follow the instructions for heating powders that use PEG.

How to make injectable steroid oils , please check this blog.